Tuning tom toms often confuses many drummers. It could be because, frequently, drummers do not tune them to specific notes. There are, of course, some exceptions – like the awe-inspiring Terry Bozzio, who tunes the 31 toms on his enormous kit both chromatically and diatonically. The other aspect that can make tuning toms a bit more tricky than tuning a snare drum or bass drum is that toms produce a lot more overtones. These additional overtones can occasionally make it challenging to hear the true pitch of the drum.

So then how are we supposed to tune our toms if we are not tuning them to specific notes and we have to deal with the complexity of their overtones? I would like to present some simple tuning guidelines that can assist any drummer attain the desired tone and sound from their toms.

Don\’t Tune Your Toms While They Are Set Up

Most drummers understand the basic rule of tuning – tap along the perimeter of the drum near each tension rod, choose a pitch, and tune each tension rod to attain the same pitch all the way around. The mistake most drummers make, however, is that they attempt to tune the toms while they are set up. The problem with this method is that you are hearing both heads resonating fully as you tap, and cannot accurately hear the specific pitch that you are trying to achieve.

The first step that I always suggest when tuning your toms is to remove them from their stands or mounts and lay them on a soft surface (like a drum throne), one at a time. This goes for floor toms as well. When you do this, you are now only listening to one head at a time, which makes it much simpler to distinguish the true pitch of your toms/drum.

Relationship Between the Heads

Unless you are using a single headed concert tom, your toms consist of two heads. The relationship between the two heads plays a critical role in their sound. In general, the bottom or resonant head should be tuned slightly higher than the batter side or the head that you strike. The batter head gives you the desired pitch and the bottom head enables the drum to hold that pitch. If the bottom head is tuned too low, you may get a funny pitch bend that descends. Alternately, if the resonant head is tuned too high you\’ll get the opposite effect with a pitch bending upward.

When assessing the relationship between the heads, I like to place the drum on its side on a soft surface (like a drum throne) to protect the finish. Then, I mute one head with one hand while hitting the opposite head with my other hand. By muting one head while tapping the other, I can clearly hear the pitch of each head since I\’m only listening to one head at a time. If I find that the relationship between the two heads is off, but I know that the drum is in tune in terms of equal tension on all of the rods, I can quickly raise or lower the pitch of both heads by systematically turning each tension rod an equal number of turns either clockwise or counterclockwise.

I hope these basic tips help you tune your toms more consistently and efficiently. Just remember to take your time and be patient. Your tuning skills will improve over time to the point where it becomes second nature.

Good luck!